The ACA-E is fully compatible with Hochiki's ESP Analogue Addressable Protocol and incorporates a thermal element and 'flat response' optical chamber.

Clockwise from top: MCP-W (Weatherproof Call Point), MCP-E (Internal Call Point), YBN-R/3 Analogue Standard Base, YBO-R/SCI (Short-Circuit Isolator Base).

The AIE-E is an Ionisation Sensor, which is fully compatible with Hochiki's ESP Analogue Addressable Protocol.

The ALG-E is fully compatible with Hochiki's ESP Analogue Addressable Protocol and is also available in black which makes it ideal for nightclubs and cinemas where aesthetic is required.

The CHQ-B is designed to provide two sounder outputs with full fault monitoring. The monitor input can be used for local power supply fault monitoring or as a general-purpose input.

The CHQ-BS comprises of a low profile design sounder and base for the analogue sensor, allowing solid state addressing either automatically by the control panel or remotely by using the TCH-B100 ESP device manager.

Fitting the optical cover means the CHQ-BS can be used as a wall-sounder.

The CHQ-BS can be installed quickly and efficiently producing significant savings in labour costs by only wiring to one unit.

The CHQ-FIO is intended to be incorporated into equipment such as fire damper panels, aspirated fire detection panels etc, to allow their connections on loops using the Hochiki ESP Communication protocol.

The CHQ-MZ is designed to allow the CDX range of detectors to be interfaced to Hochiki's ESP analogue addressable system.

The CHQ-R has been designed to provide two general purpose relay outputs, each output can be driven separately for control of such devices as dampers or control of plant and equipment shut down.

The CHQ-S monitors independent volt free contacts, which can be selected as either normally open or normally closed.

The CHQ-SIO is designed to prove a single mains rated relay output (via the flying leads), for the control of such devices as dampers, extractors or plant and equipment shutdown.

The CHQ-Z is a Dual Zone Monitor designed to allow the CDX range detectors to be interfaced to Hochiki's ESP analogue addressable system.

The CHQ-Z (I.S.) is a Dual Zone I.S. interface designed to allow Hochiki's intrinsically safe conventional detectors, to be interfaced to Hochiki's ESP analogue addressable system.

The ALG-E is fully compatible with Hochiki's ESP Analogue Addressable and is also available in black which makes it ideal for nightclubs and cinemas where aesthetic detection is required.

The MCP-E is a manual break-glass call point, which is fully compatible with Hochiki's ESP analogue addressable protocol.

The MCP-E incorporates a red LED mounted on the front cover, which flashes with communications polling and is continuously lit when the MCP-E is operated.

The unit is also available in high-visibility yellow casing

The MCP-W is an IP67 rated waterproof manual break-glass call point, which is fully compatible with Hochiki's ESP analogue addressable protocol

The TCH-B100 is a hand hell address programmer designed to address ESP devices such as Sensors, Sounders and Beacons. 

The YBN-R/3 is an electronics-free common mounting base supplied with square cable clamps for secure and reliable cable termination.

The YBN-UA is a recess adaptor which allows bases and their detectors/sensors from the CDX/ESP range to flush mounted.

The YBO-R/SCI is a Loop Isolator, which is fully compatible with Hochiki's ESP analogue addressable protocol and therefore compatible with any of the ESP sensors

The YBO-R/SCI is fully compatible with any of the ESP sensors and can be used instead of the standard YBN-R3 Base reducing costs and improving functionality.

The YBN-R/3 is an electronic-free common mounting base supplied with square cable clamps for secure and reliable cable termination.